Subaru Crosstrek Service Manual: Replacement
BRAKE > Brake Fluid
REPLACEMENT
CAUTION:
• Do not let brake fluid come into contact with the painted surface of the vehicle body. Wash away with water immediately and wipe off if it is spilled by accident.
• Do not reuse drained brake fluid. When refilling brake fluid, always refill new brake fluid.
• Avoid mixing brake fluid of different brands or different grades even from the same brand to prevent fluid performance from degrading.
• Do not allow dirt or dust to get into the reservoir tank.
NOTE:
• During the operation, keep the reservoir tank filled with brake fluid to prevent entry of air.
• Operate the brake pedal slowly and depress it fully.
• For convenience and safety, perform the work with 2 people.
• The required amount of brake fluid is approximately 500 mL (16.9 US fl oz, 17.6 Imp fl oz) for the entire brake system.
1. Lift up the vehicle.
2. Remove both the front and rear wheels.
3. Drain brake fluid from the reservoir tank.
4. Replenish the reservoir tank with the recommended brake fluid, and perform the same procedure as for bleeding the brake line on each brake caliper. Air Bleeding > PROCEDURE">
Preparation items:
Recommended brake fluid: FMVSS No. 116, DOT3 or DOT4
NOTE:
Repeat the full stroke depressing operation of the brake pedal 20 times slowly on each brake caliper, until new brake fluid comes out from transparent vinyl tube.
Inspection
BRAKE > Brake FluidINSPECTIONCAUTION:• Do not let brake fluid come into contact with the painted surface of the vehicle body. Wash away with water immediately and wipe off if it is spilled by ...
Brake hose
...
Other materials:
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Oil Temperature SensorREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from t ...
Maintenance precautions
When maintenance and service are required,
it is recommended that all work be
done by an authorized SUBARU dealer.
If you perform maintenance and service
by yourself, you should familiarize yourself
with the information provided in this
section on general maintenance and
service for your SU ...
Installation
EXTERIOR/INTERIOR TRIM > Side GarnishINSTALLATIONCAUTION:Do not reuse the garnish assembly. Deformation occurs on the garnish assembly when once removed, and this may cause improper adhesion.1. Install each part in the reverse order of removal.2. Install the garnish assembly - fender and the garn ...
