Subaru Crosstrek Service Manual: Removal

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

Remove the passenger’s side by referring to driver’s side.

1. Remove the headrest assembly.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the front seats. Front Seat > REMOVAL">

4. Separate the backrest assembly and the seat cushion assembly. Front Seat > DISASSEMBLY">

5. Remove the side airbag module.

CAUTION:

Do not open the protective cover of the side airbag module. If any damage is present in the protective cover or the cloth of side airbag module comes out from the protective cover slit, replace the side airbag module with a new part.

(1) Remove the plastic fastener at the back side (bottom) of backrest assembly.

(2) Open the fastener at the rear side of backrest assembly.

If it is hard to open, use a metal clip, etc.

(3) Remove the hexagon cap nut and nuts.

(4) While taking care not to damage the airbag protective cover, remove the side airbag module.

Installation

Side airbag sensor

Other materials:

Radio
Usually, a problem with radio reception does not mean there is a problem with the radio - it is just the normal result of conditions outside the vehicle. For example, nearby buildings and terrain can interfere with FM reception. Power lines or phone wires can interfere with AM signals. And ...

Adjustment
SECURITY AND LOCKS > Impact SensorADJUSTMENT1. CHECK IMPACT SENSOR1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the windows.3. Close all the doors and rear gate. Leave open the front hood.4. Press the LOCK button of the keyless transmitter or access ...

Installation
SEAT BELT SYSTEM > Rear Seat BeltINSTALLATION1. SEAT BELT OUTER - REAR RH & LH1. Before installation, perform a unit inspection of retractor. Rear Seat Belt > INSPECTION">2. Install the seat belt outer - rear.CAUTION:• During installation, make sure that the seat belts are n ...