Subaru Crosstrek Service Manual: Removal
AIRBAG SYSTEM > Front Sub Sensor
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the bumper face - front. Front Bumper > REMOVAL">
NOTE:
When removing the front sub sensor, remove the bumper beam COMPL - front as necessary.
4. Remove the bolt, and then detach the front sub sensor. Airbag Connector > PROCEDURE">
Installation
AIRBAG SYSTEM > Front Sub SensorINSTALLATIONCAUTION:• If the airbag has been activated, replace the front sub sensor with a new part.• Do not reuse the bolt and nut.Always replace with ...
Other materials:
Dtc p2764 torque converter clutch pressure control solenoid control circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2764 TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:No lock-up occurs.CAUTION:Use the check ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check board connector.Connector & terminalNo. 12 (+) — No. 42 (−):(A)+ probe(B)− probe3 ...
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid ValveREMOVAL1. Disconnect the ground cable from battery.2. Remove the bolt which holds the purge control solenoid valve onto intake manifold.NOTE:Hold the purge control solenoid valve unit by hand to prevent it from r ...