Subaru Crosstrek Service Manual: Removal

1. CROSSTREK MODEL

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.

1. Turn the ignition switch to OFF.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the screws and clips, and remove the trim panel - rear quarter pillar UPR. (On the side where the curtain airbag sensor is removed)

4. Remove the rear seat cushion assembly. Rear Seat > REMOVAL">

5. Release the clips and claws, and then remove the side sill cover - rear INN. (On the side where the curtain airbag sensor is removed)

CAUTION:

Do not pull with excessive force. Doing so may damage the claws of the side sill cover - rear INN.

6. Remove the mat - rear floor CTR and the spacer - rear floor side.

7. Remove the clips, and remove the trim panel - rear skirt.

8. Remove the trim panel - rear apron. (On the side where the curtain airbag sensor is removed)

(1) Remove the caps, and remove the bolts.

(2) Remove the screws.

(3) Disengage the clips, and remove the trim panel - rear apron.

NOTE:

For LH side, disconnect the connector of the luggage room light.

9. Remove the nuts and then remove the curtain airbag sensor. Airbag Connector > PROCEDURE">

Installation

Driver s airbag module

Other materials:

Inspection
SECURITY AND LOCKS > Door Lock Control SystemINSPECTION1. SYMPTOM CHARTSymptomsRepair orderReferenceThe door lock control system does not operate.1. Remove and visually inspect the following fuses.• No. 3 (in fuse & relay box)• No. 7 (in fuse & relay box)• No. 8 (in main ...

Caution
COOLING(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, fender cove ...

Dtc b1613 front sub sensor rh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1613 FRONT SUB SENSOR RH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of front sensor bus (RH)• Front sub sensor (RH) is fa ...