Subaru Crosstrek Service Manual: Removal
WIPER AND WASHER SYSTEMS > Washer Tank and Motor
REMOVAL
1. WASHER TANK
1. Open the hood COMPL - front.
2. Disconnect the ground cable from battery. NOTE">
3. Remove the bumper face - front. Front Bumper > REMOVAL">
4. Remove the tank - washer assembly.
(1) Remove the clip of the holder - windshield washer tank.
(2) Disconnect the connector from the motor pump assembly - washer and the sensor - washer tank, and then remove the harness clip.
(3) Prepare a container before disconnecting the hose - washer, and drain all washer fluid in the tank - washer.
(4) Remove the bolt and nuts and remove the tank - washer assembly.
2. WASHER MOTOR
1. Open the hood COMPL - front.
2. Disconnect the ground cable from battery. NOTE">
3. Remove the screws and clips, turn over the mud guard - front LH, and disconnect the connector of the fog light assembly - front. (Model with fog light)
4. Disconnect the connector from the motor pump assembly - washer and remove the harness clip.
5. Prepare a container before disconnecting the hose - washer, and drain all washer fluid in the tank - washer.
6. Remove the motor pump assembly - washer from the tank - washer.
Inspection
WIPER AND WASHER SYSTEMS > Washer Tank and MotorINSPECTION1. WASHER PUMPApply battery voltage to the connector terminal of the motor pump assembly - washer, and make sure that the motor operates.2. ...
Installation
WIPER AND WASHER SYSTEMS > Washer Tank and MotorINSTALLATION1. Install each part in the reverse order of removal.CAUTION:• Install so that the front end of the under cover (b) comes inside th ...
Other materials:
Parking brake
To set the parking brake, depress the
brake pedal firmly and hold it down until
the parking brake lever is fully pulled up.
To release the parking brake, pull the lever
up slightly, press the release button, then
lower the lever while keeping the button
pressed.
When the parking brake i ...
Electrical specification
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. RADAR SENSORTerminal No.ContentMeasuring conditionStandardRadar sensor LH (master)Radar sensor RH (slave)1 ←> Chassis groundPrivate CAN HPrivate CAN HAlways1 M? or more2 &larr ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSPECTION1. Check that the knock sensor has no deformation, cracks or other damages.2. Measure the resistance between knock sensor terminals.Terminal No.Standard1 and 2560±28 k? ...
