WIPER AND WASHER SYSTEMS > Rear Washer
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear gate UPR.
(1) Remove the claws on the trim edge.
(2) Release the claws in the center of trim, and remove the trim panel - rear gate UPR.
3. Remove the roof spoiler assembly. (Model with roof spoiler) Roof Spoiler > REMOVAL">
4. Remove the light assembly - high-mounted.
(1) Remove the nut.
(2) Disconnect the connector and remove the light assembly - high-mounted.
5. Remove the nozzle - rear washer.
CAUTION:
Before removing, apply protective tape to the body panel and used tools not to damage the panel - rear gate.
(1) Push the claw using a flat tip screwdriver, etc.
(2) When the nozzle - rear washer lifts up, pull out the nozzle - rear washer using a clip remover, etc.
(3) Disconnect the hose - rear washer, and remove the nozzle - rear washer.
General diagnostic table Inspection
ENGINE (DIAGNOSTICS)(H4DO) > General Diagnostic TableINSPECTION1. ENGINENOTE:Malfunction of parts other than those listed is also possible. Engine Trouble in General">SymptomsFaulty parts1. Engine stalls during idling.1) Manifold absolute pressure sensor2) Mass air flow and intake air te ...
Electrical specification
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. RADAR SENSORTerminal No.ContentMeasuring conditionStandardRadar sensor LH (master)Radar sensor RH (slave)1 ←> Chassis groundPrivate CAN HPrivate CAN HAlways1 M? or more2 &larr ...
Dtc p0963 pressure control solenoid "a" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0963 PRESSURE CONTROL SOLENOID "A" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Engine speed increases abruptly, and can ...