Subaru Crosstrek Service Manual: Removal
WIPER AND WASHER SYSTEMS > Front Wiper Arm
REMOVAL
1. MODELS WITHOUT EyeSight
1. Remove the cover - windshield wiper arm.
2. Remove the nuts, and remove the arm assembly - windshield wiper.
2. MODELS WITH EyeSight
1. Remove the cover - windshield wiper arm.
2. Remove the arm assembly - windshield wiper.
(1) Remove the nuts, and remove the arm assembly - windshield wiper.
(2) Add the alignment mark (a), and remove the hose from the arm assembly - windshield wiper assistor.
3. When removing the hose from the joint - washer hose, refer to the removal of “Nozzle wiper arm washer & hose”. Front Washer Nozzle and Hose > REMOVAL">
CAUTION:
Do not remove the nozzle - wiper arm washer from the arm assembly - windshield wiper assistor.
If nozzle replacement is required, replace the arm assembly - windshield wiper assistor as a unit.
Adjustment
WIPER AND WASHER SYSTEMS > Front Wiper ArmADJUSTMENT1. Operate the windshield wiper once.2. Check that the wiper blade is aligned with the point mark.3. Make sure that there is a gap of 1 mm (0.04 ...
Installation
WIPER AND WASHER SYSTEMS > Front Wiper ArmINSTALLATION1. MODELS WITHOUT EyeSight1. Install the arm assembly - windshield wiper.(1) Assemble the arm assembly - windshield wiper so that the blade ass ...
Other materials:
Read diagnostic trouble code (dtc) Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» dis ...
Removal
LIGHTING SYSTEM > Hazard SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the center grille assembly. Air Vent Grille > REMOVAL">3. Release the claws, and remove the switch - hazard from the center grille assembly. ...
Adjustment
CLUTCH SYSTEM > Clutch SwitchADJUSTMENT1. Loosen the lock nut of the clutch start switch.(A)Lock nut(B)Clutch start switch2. Disconnect the harness connector of the clutch start switch.3. Remove the snap pin and clevis pin connecting the clutch pedal and operating rod.(A)Clevis pin(B)Snap pin(C)P ...
