WIPER AND WASHER SYSTEMS > Combination Switch (Wiper)
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the cover assembly - column.
(1) Release the clips, and remove the cover assembly - steering UPR.
(2) Remove the screws by turning the steering wheel to right and left.
(3) Remove the cap - key cylinder (a). (Model with keyless access with push button start)
(4) Release the claw, and remove the cover assembly - column UPR and the cover assembly - column LWR.
A | Model without keyless access with push button start | B | Model with keyless access with push button start |
3. Remove the switch assembly - combination wiper select.
(1) Disconnect the connector.
(2) Release the claws, and pull out the switch assembly - combination wiper select.
CAUTION:
Do not press the claws with excessive force. They may be damaged.
Dtc b14e5 mode door actuator stepping motor circuit open
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E5 MODE DOOR ACTUATOR STEPPING MOTOR CIRCUIT OPENDTC detecting condition:Mode door actuator stepping motor circuit is open.Trouble symptom:Vent does not change.Wiring diagram:Air conditioning syst ...
Using the phone switch/microphone
Steering switch
By pressing the steering switch, a call can
be received or ended without taking your
hands off the steering wheel.
Volume control switch
Off hook switch
On hook switch
Microphone
The microphone is used when talking on
the phone.
Type A
Type B
How ...
Installation
AIRBAG SYSTEM > Side Airbag SensorINSTALLATIONCAUTION:Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.1. Before installation, inspect the following items and replace any faulty part with a new part.• The side airbag sensor, sensor bracket, or connector are ...