VEHICLE DYNAMICS CONTROL (VDC) > VDC OFF Switch
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the cover assembly - instrument panel LWR driver OUT. Instrument Panel Lower Cover > REMOVAL">
3. Remove the screws and release the claws, then detach the cover.
4. Release the claws and remove the VDC OFF switch.
Installation
DIFFERENTIALS > Rear Differential Front MemberINSTALLATION1. Install the rear differential front member, and temporarily attach and tighten a new self-locking nut.2. Remove the transmission jack.3. Tighten the self-locking nut.Tightening torque:T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)T2: 110 N&m ...
Low fuel warning light
The
low fuel warning light illuminates
when the tank is nearly empty, at approximately
2.6 US gal (10.0 liters, 2.2 Imp gal).
It only operates when the ignition switch is
in the "ON" position.
CAUTION
Promptly put fuel in the tank whenever
the low fuel warning light
illuminates. Engine ...
Safety precautions
WARNING
Bulbs may become very hot while
illuminated. Before replacing
bulbs, turn off the lights and wait
until the bulbs cool down. Otherwise,
there is a risk of sustaining
a burn injury.
For models with HID low beam
headlights, observe the following
precautions. Not doing so carries
the ...