Subaru Crosstrek Service Manual: Removal

1. 5 DOOR MODEL

1. Disconnect the ground cable from battery.

2. Lift up the vehicle, and then remove the rear wheels.

3. Remove the rear ABS wheel speed sensor.

CAUTION:

• Be careful not to damage the sensor.

• Do not apply excessive force to the sensor harness.

• Leave the sensor harness clamp (white arrow) on the vehicle side.

(1) Tilt the backrest assembly of the rear seat forward.

(2) Remove the clips located at the bottom of the cover COMPL - rear backrest LH and RH of the rear seat back.

(3) Remove the mat - rear floor CTR and the spacer - rear floor side.

(4) Remove the clips, and remove the trim panel - rear skirt.

(5) Remove the lid upper rear (a) and the cap - rear strut (b) in the order from (1) to (6).

(6) Disconnect the connector of the rear ABS wheel speed sensor.

(7) Remove the grommet from the rear wheel housing, and pull out the connector of the rear ABS wheel speed sensor.

(8) Remove the harness clip and bolt, and remove the rear ABS wheel speed sensor.

Inspection

Installation

Other materials:

Inspection
TELEMATICS SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEWhen communication with DCM is impossibleDetecting condition:• Defective harness connector• Power supply circuit malfunction• Defective DCM• Defective CAN communica ...

Dtc b1578 meter
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1578 METERDTC DETECTING CONDITION:• Except for C5 modelReference code incompatibility between combination meter and body integrated unit or communication failure between body integrated unit and ECM&bull ...

Hazard warning flasher
Models without multi function display Models with multi function display The hazard warning flasher is used to warn other drivers when you have to park your vehicle under emergency conditions. The hazard warning flasher works regardless of the position of the ignition switch. To ...