Subaru Crosstrek Service Manual: Removal
STARTING/CHARGING SYSTEMS(H4DO) > Starter
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the clip (A) from the air intake boot.
3. Loosen the clamp (B) securing the air cleaner case (rear) to the air intake boot.
4. Loosen the clamp (C) which secures the throttle body to the air intake boot.
5. Remove the air intake boot from the throttle body, and place the air intake boot aside so that it does not interfere with the work.
6. Disconnect the connector (B) and terminal (A) from starter.
7. Disconnect the terminal (A) from the cable stay and remove the cable stay and starter from the transmission.
CAUTION:
In order to prevent damaging the terminal (A), fix the terminal (A) when loosing the bolt, and avoid the part from rotating together while loosening the bolt.
NOTE:
For CVT model, a nut is used at (a).
Assembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterASSEMBLY1. Apply grease to the shaft sliding surfaces of the internal gear assembly.Grease:Multemp #6129 or equivalent2. Assemble the shaft to the internal ...
Disassembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterDISASSEMBLYCAUTION:The starter should be placed through a no-load test whenever it has been overhauled.1. Disconnect the cable from the magnet switch assemb ...
Other materials:
Dtc p0222 throttle/pedal position sensor/switch "b" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0222 THROTTLE/PEDAL POSITION SENSOR/SWITCH "B" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performance• Engin ...
Adjustment
DIFFERENTIALS > Rear Differential (T-type)ADJUSTMENT1. SIDE GEAR BACKLASHAdjust the side gear backlash. Rear Differential (T-type) > ASSEMBLY">2. HYPOID DRIVEN GEAR BACKLASHAdjust hypoid driven gear backlash. Rear Differential (T-type) > ASSEMBLY">3. TOOTH CONTACT BETWEEN ...
Dtc b1771 buckle switch
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1771 BUCKLE SWITCHDIAGNOSIS START CONDITION:Ignition voltage is 8 V to 16 V.DTC DETECTING CONDITION:• Passenger’s seat buckle switch is faulty.• Passenger’s buckle switch ...
