Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

SECURITY AND LOCKS > Remote Openers

REMOVAL

1. FRONT HOOD OPENER

1. Remove the opener handle.

(1) Remove the cable.

(2) Remove the bolt, and remove the opener handle.

2. After removing the following parts, attach a string to the end of the cable - front hood and remove the cable clip and the cable.

Lock assembly - front hood: Front Hood Lock Assembly > REMOVAL">

Cover assembly - instrument panel LWR driver: Instrument Panel Lower Cover > REMOVAL">

2. FUEL FLAP OPENER

1. Remove the cover - handle.

(1) Open the cover by using a flat tip screwdriver.

(2) Remove the screws and detach the cover - handle.

2. Remove the pull handle - opener.

(1) Remove the nut.

(2) Remove the cable from pull handle - opener.

3. Remove the trim panel - rear apron RH. Rear Quarter Trim > REMOVAL">

4. Remove the fuel lock inside the quarter panel.

(1) Press the claws of the fuel lock.

(2) While keeping the condition in step (1), pull the fuel lock to the rearward of the vehicle.

5. Remove the lower inner trim. Lower Inner Trim > REMOVAL">

6. Remove the cable clip, and remove the cable.

Inspection
SECURITY AND LOCKS > Remote OpenersINSPECTIONCheck if the front hood and fuel flap operate normally. ...

Installation
SECURITY AND LOCKS > Remote OpenersINSTALLATION1. Before installation, check the following items.• Cable is free from deformation such as fray.2. Install each part in the reverse order of rem ...

Other materials:

Removal
CONTROL SYSTEMS > Select CableREMOVAL1. Shift the select lever to “N” range.2. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.3. Lift up the vehicle.4. Remove the center exhaust pipe. Cen ...

Audio set
Your vehicle may be equipped with one of the following audio sets. Refer to the pages indicated in this section for operating details. CAUTION Always consult your SUBARU dealer before installing a citizen band radio or other transmitting device in your vehicle. Such devices may caus ...

Removal
MECHANICAL(H4DO) > V-beltREMOVALNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. V-BELT1. When working on the vehicleNOTE:When working on the vehicle, perform the following steps also.(1) Remove the V-belt covers.(2) Remove the air intake duct. Ai ...

© 2016-2024 Copyright www.sucross.com