SECURITY AND LOCKS > Receiver
REMOVAL
NOTE:
Except for model with keyless entry
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">
3. Remove the receiver assembly.
(1) Disconnect the connector.
(2) Remove the bolt and remove the receiver assembly.
Adjustment
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)ADJUSTMENT1. VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight)After installing, replacing or adjusting the following parts, perform the VDC sensor midpoint setting mode.• Steering angle se ...
Disassembly
CONTROL SYSTEMS > MT Gear Shift LeverDISASSEMBLY1. Remove the lock wires.(A)Lock wire2. Remove the rod from gear shift lever.(A)Rod(B)Lever(C)Stay3. Separate the rod and inner boot.4. Remove the snap ring from the stay.(A)Snap ring5. Separate the gear shift lever and the stay.6. Remove the boot a ...
Inspection
COOLING(H4DO) > Radiator Fan SystemINSPECTIONOperating condition:Vehicle speedA/C compressor loadEngine coolant temperatureIncrease: 98°C (208°F) or lessDecrease: 96°C (205°F) or lessIncrease: 99 — 101°C (210 — 214°F)Decrease: ...