Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > Rear Outer Handle
REMOVAL
1. Raise the glass assembly - rear door to the top position.
2. Disconnect the ground cable from battery. NOTE">
3. Remove the trim panel - rear door. Door Trim > REMOVAL">
4. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL">
5. Remove the screws and move downward the latch & actuator assembly - rear.
CAUTION:
Do not re-use the screws. Always replace with a new part.
6. Remove the holder of the frame assembly - rear door outer.
7. Remove the cover - handle rear outer.
Preparation tool:
TORX® T30
(1) Loosen the TORX® bolt.
(2) Release the claws, and then remove the cover - handle rear outer.
8. Remove the handle - door outer by moving it rearward.
CAUTION:
Do not apply excessive force to remove the handle - door outer from the panel assembly - rear door. The panel assembly - rear door may be deformed.
9. Remove the frame assembly - rear door outer.
Preparation tool:
TORX® T30
(1) Remove the spacer - door handle outer.
(2) Loosen the TORX® bolt and remove the frame assembly - rear door outer from inside the panel assembly - rear door.
Inspection
SECURITY AND LOCKS > Rear Outer HandleINSPECTIONCheck if the outer handle operates normally.If the lever is faulty, replace the handle - door outer. ...
Installation
SECURITY AND LOCKS > Rear Outer HandleINSTALLATION1. Before installation, check the following items.• Lever is free from deformation.• Grease is applied sufficiently to lever joints.If ...
Other materials:
Preparation tool
WIPER AND WASHER SYSTEMS > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to ...
Dtc c1252 wheel speed sensor signal of one of the wheels
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1252 WHEEL SPEED SENSOR SIGNAL OF ONE OF THE WHEELSDTC detecting condition:• Defective ABS wheel speed sensor signal (noise, irregular signal, etc.)• Defective magnetic encoder&b ...
Conditions in which front passenger's SRS frontal airbag is not activated
The front passenger's SRS frontal airbag
will not be activated when any of the
following conditions are met regarding the
front passenger's seat:
The seat is empty.
The seat is equipped with an appropriate
child restraint system and an infant
is restrained in it. (See WARNING that
fol ...
