SECURITY AND LOCKS > Rear Gate Opener Button
REMOVAL
NOTE:
• The button - opener rear gate is integrated with the rear lock button. (Model with keyless access with push button start)
• Open the panel - rear gate before disconnecting the ground terminal from the battery.
1. Disconnect the ground cable from battery. NOTE">
2. Remove the garnish assembly - rear gate. Rear Gate Garnish > REMOVAL">
3. Release the locks at both ends of the button - opener rear gate by pushing them with a flat tip screwdriver, and remove the button - opener rear gate.
4. Remove the screws, and remove the rear lock button, and remove the integrated harness. (Model with keyless access with push button start)
Refrigerant recovery procedure Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Recovery ProcedurePROCEDURECAUTION:• During operation, be sure to wear protective goggles and protective gloves.• Connect the refrigerant recovery system with the manifold gauge set to discharge the refrigerant from the A/C system ...
Dtc b1655 front buckle switch rh failure
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1655 FRONT BUCKLE SWITCH RH FAILUREDiagnosis start condition:Ignition voltage is 8 V to 16 V.DTC detecting condition:• Passenger’s buckle switch circuit is open, shorted or shorted to ...
Engine electrical system Wiring diagram
WIRING SYSTEM > Engine Electrical SystemWIRING DIAGRAM1. WITHOUT PUSH BUTTON START2. WITH PUSH BUTTON START ...