SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator Assembly
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear door. Door Trim > REMOVAL">
3. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL">
4. Remove the glass assembly - rear door. Rear Door Glass > REMOVAL">
5. Remove the screws to remove the latch & actuator assembly - rear.
CAUTION:
Do not re-use the screws. Always replace with a new part.
Type B
1. Turn the airflow mode selection dial
and fan speed control dial to the "AUTO"
position.
2. Set the preferred temperature using
the temperature control dial.
NOTE
Each function can be individually
set to the AUTO mode independently of
the other functions. Any function set to
the A ...
Preparation tool
SPEED CONTROL SYSTEMS(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer ...
Electrical component location Location
AIRBAG SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Front sub sensor (RH)(11)Side airbag sensor (RH)(20)Satellite safing sensor(2)Front sub sensor (LH)(12)Seat belt pretensioner (LH)(21)Occupant detection control module(3)Airbag control module(13)Seat belt pretensioner (RH)(22)B ...