Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > Keyless Access Outdoor Antenna
REMOVAL
1. FRONT ANTENNA
CAUTION:
Do not remove the antenna from the front door outer handle.
If replacement is needed, replace the front outer handle assembly as a set.
Remove the handle - door outer. Front Outer Handle > REMOVAL">
2. REAR ANTENNA
CAUTION:
• Do not detach the antenna except when replacing it. Detaching unnecessarily will lead to insecure attachment of the antenna.
• When replacing the antenna, do not reuse the tapping screw. Always replace with new tapping screws.
1. Disconnect the ground cable from battery. NOTE">
2. Remove the bumper face - rear. Rear Bumper > REMOVAL">
3. Remove the rear antenna assembly - exterior.
(1) Disconnect the connector.
(2) Remove the screws, and remove the rear antenna assembly - exterior.
Inspection
SECURITY AND LOCKS > Keyless Access Outdoor AntennaINSPECTION1. Check the setting by performing Keyless access system check using the Subaru Select Monitor. Keyless Access System Check > OPERAT ...
Installation
SECURITY AND LOCKS > Keyless Access Outdoor AntennaINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Rear antenna assembly - exterior: 1.5 N·m (0.2 kgf-m, 1.1 f ...
Other materials:
List
BODY CONTROL SYSTEM (DIAGNOSTICS) > Read Current DataLISTItems to be displayedUnit of measureContentNoteBATT voltage (control)10 — 15 VBody integrated unit input valueAlwaysBATT voltage (BACKUP)10 — 15 VBody integrated unit input valueAlwaysIGN Voltage10 — 15 VBody integrated unit input val ...
Dtc b1906 open in front p/t lh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1906 OPEN IN FRONT P/T LHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (LH) circuit is open.• Pretensioner (LH) is faulty.• Pretensioner harness (LH ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorINSPECTION1. CRANKSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)1. Prepare an oscilloscope.2. Remove the glove box. Glove Box > REMOVAL">3. Connect the probe to ECM connector.Terminal No.Probe16+1−4. Start the eng ...
