Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > Impact Sensor
REMOVAL
1. Pull out the key from the ignition switch, or turn off the power.
2. Close all the doors and rear gate.
3. Press the UNLOCK button of the keyless transmitter or access key.
4. Disconnect the ground cable from battery. NOTE">
5. Remove the impact sensor.
6. Change the setting of impact sensor using Subaru Select Monitor.
Adjustment
SECURITY AND LOCKS > Impact SensorADJUSTMENT1. CHECK IMPACT SENSOR1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the windows.3. Close all the doors an ...
Installation
SECURITY AND LOCKS > Impact SensorINSTALLATION1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the doors and rear gate.3. Press the UNLOCK button of the ...
Other materials:
Turn off display of driving information
display
The driving information display can be
turned off.
To turn off the display, turn the ignition
switch to the "LOCK"/"OFF" position and
press the "+" button adjacent to the clock
display for approximately 5 seconds.
Then, the driving information display and
the clock display will blink for ...
Caution
EXHAUST(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, fender cove ...
Inspection
LIGHTING SYSTEM > Light Control SensorINSPECTION1. Turn the ignition switch to ON.2. Set the lighting switch to AUTO position.3. Check the voltage between the sensor terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnection diagram2 (+) — 1 (−)Measure th ...
