SECURITY AND LOCKS > Immobilizer Antenna
REMOVAL
1. MODEL WITHOUT KEYLESS ACCESS WITH PUSH BUTTON START
1. Disconnect the ground cable from battery. NOTE">
2. Remove the cover assembly - column.
(1) Remove the screws by turning the steering wheel to right and left.
(2) Release the claw, and remove the cover assembly - column UPR and the cover assembly - column LWR.
3. Remove the immobilizer antenna assembly.
(1) Disconnect the connector.
(2) Release two claws using a flat tip screwdriver or similar tool wrapped with a protection tape, and remove the immobilizer antenna assembly.
CAUTION:
Do not apply excessive force to disengage the lock of immobilizer antenna assembly. Otherwise they may be broken because those parts are the products made of a plastic.
2. MODEL WITH KEYLESS ACCESS WITH PUSH BUTTON START
NOTE:
Immobilizer antenna is integrated with the push button ignition switch.
1. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">
2. Remove the push button ignition switch.
(1) Disconnect the connector, and remove the aspirator hose.
(2) Release the claws, and then remove the panel - switch.
(3) Release the claws, and then remove the push button ignition switch from the panel - switch.
How to read wiring diagrams
WIRING SYSTEM > Basic Diagnostic ProcedureHOW TO READ WIRING DIAGRAMS1. WIRING DIAGRAMThe wiring diagram of each system is illustrated so that you can understand the path through which the electric current flows from the battery.Sketches and codes are used in the diagrams. They should read as fol ...
Dtc u1433 invalid data received from eyesight
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1433 INVALID DATA RECEIVED FROM EyeSightDTC DETECTING CONDITION:Defective data was transmitted from stereo camera.TROUBLE SYMPTOM:Cooperation control of EyeSight does not operate properly.STEPCHECKYESNO1.CHECK ...
Lock
The key can only be inserted or removed
in this position. The ignition switch will lock
the steering wheel when you remove the
key.
If turning the key is difficult, turn the
steering wheel slightly to the right and left
as you turn the key.
The key can be turned from the "ACC" to
"LOCK" ...