Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > Front Outer Handle
REMOVAL
1. Raise the glass assembly - front door to the top position.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the trim panel - front door. Door Trim > REMOVAL">
4. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL">
5. Remove the holder of the frame assembly - front door outer.
NOTE:
For model with keyless access with push button start, disconnect the harness clip and exterior antenna (touch sensor) connector.
6. Remove the cover - handle front outer.
Preparation tool:
TORX® T30
(1) Remove the plug at the rear end of the panel assembly - front door.
(2) Loosen the TORX® bolt and remove the cover - handle front outer.
7. Remove the handle - door outer by moving it rearward.
CAUTION:
Do not apply excessive force to remove the handle - door outer from the panel assembly - front door. The panel assembly - front door may be deformed.
8. Remove the frame assembly - front door outer.
Preparation tool:
TORX® T30
(1) Remove the spacer - door handle outer.
(2) Remove the rod from the rod clamp of the frame assembly - front door outer.
(3) Loosen the TORX® bolt and remove the frame assembly - front door outer from inside the panel assembly - front door.
Inspection
SECURITY AND LOCKS > Front Outer HandleINSPECTIONCheck if the outer handle operates normally.• If the lever is faulty, replace the handle - door outer.• If the rod is deformed, replace ...
Installation
SECURITY AND LOCKS > Front Outer HandleINSTALLATION1. Before installation, check the following items.• Rod is free from deformation.• Grease is applied sufficiently to rod joints.If gre ...
Other materials:
Removal
GLASS/WINDOWS/MIRRORS > Outer Mirror AssemblyREMOVALRefer to “DISASSEMBLY” for removal procedures of scalp cap and mirror face. Outer Mirror Assembly > DISASSEMBLY">1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE&quo ...
Specification
TELEMATICS SYSTEM (DIAGNOSTICS) > Control Module I/O SignalSPECIFICATION1. DATA COMMUNICATION MODULE (DCM)Terminal No.ContentMeasuring conditionStandardA1 — — — A2 — — — A3LED GREEN — — A4 ←> Chassis groundi-buttoni-button OFF > ON1.6 k? or more > less than 1 ?A ...
Cruise control indicator light (if equipped)
This
light illuminates when the cruise
control main button is pressed to activate
the cruise control function. For details,
refer to "To set cruise control"
CAUTION
If the CHECK ENGINE warning light/
malfunction indicator light illuminates,
the cruise control indicator
light flashes at t ...
