SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator Assembly
REMOVAL
1. Raise the glass assembly - front door to the top position.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the trim panel - front door. Door Trim > REMOVAL">
4. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL">
5. Remove the rod from the rod clamp of the frame assembly - front door outer.
6. Remove the cover - handle front outer. Key Lock Cylinders > REPLACEMENT">
7. Remove the sash COMPL - lower.
(1) Remove the lower side of the running channel - front door.
(2) Remove the bolts, and remove the sash COMPL - lower.
8. Remove the screws to remove the latch & actuator assembly - front.
CAUTION:
Do not re-use the screws. Always replace with a new part.
Dtc b2903 vdc data error
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2903 VDC DATA ERRORDTC DETECTING CONDITION:Detected when data (vehicle speed signal) from VDC CM is abnormal.TROUBLE SYMPTOM:The auto headlight beam leveler does not operate.NOTE:Perform ...
Loading your vehicle
WARNING
Never allow passengers to ride
on a folded rear seatback or in
the cargo area. Doing so may
result in serious injury.
Never stack luggage or other
cargo higher than the top of the
seatback because it could tumble
forward and injure passengers in
the event of a sudden stop ...
Diagnostics with phenomenon Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Diagnostics with PhenomenonINSPECTIONSymptomsFaulty partsStall speed is low after warming-up, with select lever in “D” or “R” range.Engine control systemVehicle does not move despite engine speed rising up, with select lever in & ...