Subaru Crosstrek Service Manual: Removal
SEATS > Rear Seat
REMOVAL
CAUTION:
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
• Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the rear seat cushion assembly.
(1) Push the corners of the rear seat cushion from above.
(2) While pushing the corners of the rear seat cushion from above, pull the knob of the hook - seat cushion rear towards yourself.
(3) While pulling the knob towards yourself, disconnect the hooks by lifting up the rear seat cushion.
NOTE:
Pull the left side of the knob to disconnect the LH side hook, and pull the right side of the knob to disconnect the RH side hook.
(4) Remove the hook (A) by pushing it back while lifting the front side of the rear seat cushion, and remove the rear seat cushion.
3. Remove the backrest assembly LH.
(1) Tilt the backrest assembly LH forward.
(2) Remove the clips located at the bottom of the cover COMPL - rear backrest LH and RH of the rear seat back.
(3) Turn over the cover COMPL - rear backrest LH to remove the bolts.
(4) Remove the backrest assembly LH from the hinge assembly.
NOTE:
The backrest assembly cannot be removed unless pin positions on the hinge assembly side and backrest assembly side are aligned.
4. Remove the backrest assembly RH.
(1) Remove the bolts and nuts.
(2) Remove the backrest assembly RH from the hinge assembly.
NOTE:
The backrest assembly cannot be removed unless pin positions on the hinge assembly side and backrest assembly side are aligned.
Assembly
SEATS > Rear SeatASSEMBLYCAUTION:• Do not reuse hog rings.• Secure the hog ring using hog ring pliers.• Install the hog rings to the specified points securely and make sure that t ...
Disassembly
SEATS > Rear SeatDISASSEMBLY1. Remove the rear seat. Rear Seat > REMOVAL">2. Remove the headrest assembly - rear backrest.3. Remove the armrest assembly - rear center. (model with armre ...
Other materials:
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveINSPECTION• Make sure the cutout of the reverse accent shaft is aligned with the opening in the reverse check sleeve.• Turn the cam by hand to check for smooth rotation.• Move the cam and shaft all the way toward th ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainINSTALLATION1. Clean the mating surface of oil pump chain cover and converter case.2. Using the ST, install the oil seal.NOTE:• Use a new oil seal.• Apply CVTF to the oil seal lip and press-fitting surface.ST 499755602PRESS ...
Map lights
Type A
Type B
To turn on the map light, push the switch.
To turn it off, push the switch again.
NOTE
For the type A map lights, although the
light switches are in the ON position,
the lights are automatically turned off
after approximately 30 seconds of
illumination to prevent the veh ...
