Subaru Crosstrek Service Manual: Removal
SEATS > Front Seat
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Remove the headrest assembly - front.
2. Turn the ignition switch to OFF.
3. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
4. Remove the slide rail assembly installing bolt.
(1) Tilt the backrest assembly forward and move the front seat to the front most position.
(2) Remove the cover - bolt rear (A) and remove the bolts.
(3) Move the front seat to the rearmost position, and remove the bolts.
5. Disconnect the connector under the front seat.
• Seat belt warning light connector (driver’s seat)
• Occupant detection system harness connector (passenger’s seat) Airbag Connector > PROCEDURE">
• Side airbag connector Airbag Connector > PROCEDURE">
• Seat heater connector (model with seat heater)
• Buckle switch RH connector (passenger’s seat) Airbag Connector > PROCEDURE">
6. Take out the front seat from the vehicle.
CAUTION:
Be careful not to damage the body.
Assembly
SEATS > Front SeatASSEMBLYCAUTION:• Do not confuse the harness routing of the side airbag harness and the seat belt inner - front harness, etc. Assembling with harnesses improperly routed may ...
Disassembly
SEATS > Front SeatDISASSEMBLY1. DRIVER’S SEATCAUTION:Before assembling, make sure how the harnesses such as the side airbag harness and the seat belt inner - front harness are routed in order ...
Other materials:
Diagnostic procedure without diagnostic trouble code (dtc) Check shift indicator
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure without Diagnostic Trouble Code (DTC)CHECK SHIFT INDICATORDiagnosis:• CAN communication is abnormal with the combination meter.• Combination meter malfunctionTrouble symptom:• Shift indicator does not displa ...
Dtc p2746 intermediate shaft speed sensor "b" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2746 INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• ...
Inspection
GLASS/WINDOWS/MIRRORS > Rear Window Defogger SystemINSPECTION1. CHECK SYSTEMSymptomsInspection orderRear window defogger does not operate.(1) Check the fuse.(2) Check the rear defogger relay.(3) Check the rear window defogger switch.(4) Check the heat wire.(5) Check the wiring harness.(6) Check b ...
