Subaru Crosstrek Service Manual: Removal

1. SEAT BELT OUTER - FRONT

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.

• Do not drop or subject the pretensioner to any impact.

• Since the pretensioner and bracket are integrated as a unit, do not disassemble them.

1. Turn the ignition switch to OFF.

2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE">

3. Tilt the front seat backrest assembly forward, and move the front seat all the way forward.

4. Remove the rear seat cushion assembly. Rear Seat > REMOVAL">

5. Remove the cover side sill - front INN, cover side sill - rear INN, and trim panel - center pillar LWR. (On the side where seat belt assembly is removed) Lower Inner Trim > REMOVAL">

6. Remove the trim panel - center pillar UPR. (On the side where seat belt assembly is removed)

(1) Remove the cover through (a), and remove the seat belt anchor bolt.

(2) Remove the bolt on the lower side of the trim panel - center pillar UPR.

(3) Remove the clip by pulling the upper part of the trim toward you, and while lowering the entire trim, remove the trim panel - center pillar UPR.

CAUTION:

Do not reuse the upper clips of the trim panel - center pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.

7. Remove the seat belt outer - front.

(1) Turn over the floor mat to disconnect the belt tension sensor connector. Airbag Connector > PROCEDURE">

NOTE:

On the passenger’s side, also disconnect the connector of the lap seat belt pretensioner.

(2) Remove the bolt to remove the seat belt retractor.

(3) Remove the lower anchor bolt, and remove the seat belt outer - front.

• Driver’s side

8. Remove the bolts, and then remove the adjuster assembly - seat belt.

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Turn the ignition switch to OFF.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the front seats. Front Seat > REMOVAL">

4. Remove the seat belt inner - front.

(1) Remove the nut, and remove the seat belt inner - front.

(2) Remove the clip for the inner seat belt harness located under the seat cushion.

Inspection

Installation

Other materials:

Dtc p0601 internal control module memory checksum error
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0601 INTERNAL CONTROL MODULE MEMORY CHECKSUM ERRORDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:TCM ROM malfunctionSTEPCHECKYESNO1 ...

By incoming calls
On the phone (menu) screen, select the "Incoming Calls" key to open the "Incoming Calls" screen. You can make a call by selecting an item in the incoming call history list. If there is no incoming call history, a message appears to indicate that there is no incoming call history data. ...

Dtc u0156 lost communication with information center "a"
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0156 LOST COMMUNICATION WITH INFORMATION CENTER "A"DTC DETECTING CONDITION:No data is received from MFD.TROUBLE SYMPTOM:Display of MFD does not operate properly.STEPCHECKYESNO1.CHECK PERFORMING OF BAS ...