Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

REAR SUSPENSION > Rear Shock Absorber

REMOVAL

1. CROSSTREK MODEL

1. Disconnect the ground cable from battery. NOTE">

2. Lift up the vehicle, and then remove the rear wheels.

3. Remove the sensor assembly - headlight beam leveler. (Model with auto headlight beam leveler, left side only)

CAUTION:

Do not apply impact to the sensor assembly - headlight beam leveler or forcibly move the arm. Doing so may cause sensor damage and malfunction.

(1) Disconnect the connector of the sensor assembly - headlight beam leveler.

(2) Remove the nuts, and remove the sensor assembly - headlight beam leveler.

4. Remove the bolts and nuts, and lower the lateral link assembly - rear.

(1) Remove the nut and disconnect the rear stabilizer link. (Model with rear stabilizer)

(2) Remove the bolts from the lower side of rear shock absorber assembly.

(3) Disconnect the housing assembly - rear axle from the lateral link assembly - rear.

5. Remove the mat - rear floor CTR and the spacer - rear floor side.

6. Remove the clips, and remove the trim panel - rear skirt.

7. Remove the lid upper rear (a) and the cap - rear strut (b) in the order from (1) to (6).

8. Remove the nuts on the upper side of rear shock absorber assembly.

9. Lower the lateral link assembly - rear, and remove the rear shock absorber assembly.

Assembly
REAR SUSPENSION > Rear Shock AbsorberASSEMBLY1. Before assembly, check each part. Rear Shock Absorber > INSPECTION">2. Using a coil spring compressor, compress the coil spring - rear.CA ...

Disassembly
REAR SUSPENSION > Rear Shock AbsorberDISASSEMBLY1. Using a coil spring compressor, compress the coil spring.2. Using a hexagon wrench to prevent the shock absorber piston rod from turning, remove t ...

Other materials:

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Main RelayINSPECTION1. Check that the main relay has no deformation, cracks or other damages.2. Measure the resistance between main relay terminals.Terminal No.Standard1 and 21 M? or more3 and 4130.4 — 230.8 ? (when 20°C (68°F))3. Conn ...

Operation
EyeSight (DIAGNOSTICS) > ECM Cancel Code(s) DisplayOPERATION1. On «Main Menu» display, select «Each System».On «Select System» display, select «Engine Control System».2. Drive vehicle at 40 km/h (25 MPH) or more and set the cruise control.CAUTION:• When performing diagnosis, observe ...

List
TELEMATICS SYSTEM (DIAGNOSTICS) > Read Current DataLISTDisplayContentReference valueUnitTrip Count [count]Refer to “LAN SYSTEM (DIAGNOSTICS)”. General Description > CAUTION"> — — Count — — Time Count [msec] — — Current GPS DataCurrent GPS information — †...

© 2016-2024 Copyright www.sucross.com