Subaru Crosstrek Service Manual: Removal
POWER ASSISTED SYSTEM (POWER STEERING) > Universal Joint
REMOVAL
1. Adjust the tilt position of the column assembly - steering to the lowest position and lock the tilt lever.
2. Remove the universal joint assembly - steering.
(1) Place alignment marks on the universal joint assembly - steering.
NOTE:
Place alignment marks on the following positions.
• Between the column assembly - steering and the universal joint assembly - steering
• Between the steering gearbox assembly and the universal joint assembly - steering
(2) Remove the bolt, and remove the universal joint assembly - steering.
3. Prevent the steering wheel from turning using the seat belt.
Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Universal JointINSPECTIONCheck for wear, damage or any other faults.1. Check the universal joint assembly - steering for excessive looseness.Service limit:P ...
Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Universal JointINSTALLATION1. Before installation, check the universal joint assembly - steering. Universal Joint > INSPECTION">2. Adjust the ti ...
Other materials:
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Automatic Transmission AssemblyINSTALLATION1. Attach the ST to converter case.ST 498277200STOPPER SET2. When completely overhauling the transmission, refill CVTF through the transmission right side plug. Preparation for Overhaul">3. Replace ...
Dtc p0131 a/f / o2 sensor circuit low voltage bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0131 A/F / O2 SENSOR CIRCUIT LOW VOLTAGE BANK 1 SENSOR 1DTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...
Removal
MECHANICAL(H4DO) > Timing Chain AssemblyREMOVAL1. TIMING CHAIN RHNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. Remove the chain cover. Chain Cover > REMOVAL">2. Using ST and by turning the crankshaft, align the alignment marks of cra ...
