POWER ASSISTED SYSTEM (POWER STEERING) > Steering Wheel
REMOVAL
CAUTION:
Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Set the tire to the straight-ahead position.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL">
4. Remove the steering wheel.
CAUTION:
• Always use the steering wheel puller for removal to avoid deforming the steering wheel.
• If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
(1) Disconnect the connector and remove the nut.
(2) Put an alignment mark (a) using a ruler as shown in the figure, and remove the steering wheel.
Preparation tool:
Steering wheel puller
Electrical specification
CONTROL SYSTEMS > AT Shift Lock Control SystemELECTRICAL SPECIFICATION• Model without push button ignition switchItemConnector No.Terminal No.Input/Output signalMeasured value and measuring conditionsBattery power supplyB28169 — 16 V7i846Ignition power supplyB2803210 — 15 V when ignitio ...
Viewing range on the screen
CAUTION
The range that can be viewed with
the rear view camera is limited.
Always be sure to check with your
eyes when moving backward and
proceed slowly.
Range of view
Range of view
Image from camera
The area from the rear end of the bumper
can be viewed. Areas at both ends ...
Basic screens
By operating the "
" or "
" switch on the
steering wheel, you can change the
screen that is always displayed.
Default screen
Digital speedometer
Menu screen entering screen
While this screen is selected, pull the "
/
SET" switch to enter the menu screen. ...