POWER ASSISTED SYSTEM (POWER STEERING) > Steering Column
REMOVAL
CAUTION:
Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL">
3. Remove the steering wheel. Steering Wheel > REMOVAL">
4. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">
5. Remove the knee airbag module. Knee Airbag Module > REMOVAL">
6. Remove the cover assembly - column.
(1) Release the screws and claws.
(2) Remove the cap - key cylinder (a). (Model with keyless access with push button start)
(3) Remove the cover assembly - column UPR and the cover assembly - column LWR.
A | Model without keyless access with push button start | B | Model with keyless access with push button start |
7. Remove the switch assembly - combination.
(1) Disconnect the connector, and loosen the clamp to release the claws.
(2) Pull out the switch assembly - combination from the column assembly - steering.
8. Remove all connectors from the column assembly - steering.
9. Remove the universal joint assembly - steering. Universal Joint > REMOVAL">
CAUTION:
To prevent damage to the universal joint assembly - steering and improper steering effort, make sure to remove the universal joint assembly - steering.
10. Remove the two nuts under the beam COMPL - steering securing the column assembly - steering.
11. Pull out the column assembly - steering from the hole on toe board.
CAUTION:
Do not loosen the tilt lever when the column assembly - steering is not secured to the vehicle.
12. Remove the ignition key lock from the column assembly - steering. Ignition Key Lock > REPLACEMENT">
Dtc p219a bank 1 air-fuel ratio imbalance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P219A BANK 1 AIR-FUEL RATIO IMBALANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Improper idlingCAUTION:After servicing or ...
Date and time settings
The items in the date and time settings
can be set. To change the items, operate
the "
" or "
" switch.
NOTE
The "Time/Date" item must be set to
display the "Birthday", "Anniversary"
and notifications for vehicle maintenance.
The "Birthday" and "Anniversary"
items can be entered ...
Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...