MECHANICAL(H4DO) > V-belt
REMOVAL
NOTE:
When replacing a single part, perform the work with the engine assembly installed to body.
1. V-BELT
1. When working on the vehicle
NOTE:
When working on the vehicle, perform the following steps also.
(1) Remove the V-belt covers.
(2) Remove the air intake duct. Air Intake Duct > REMOVAL">
2. Attach the tool to the V-belt tensioner assembly, and rotate the tool clockwise to loosen and remove the V-belt.
2. V-BELT TENSIONER ASSEMBLY AND IDLER PULLEY
1. Remove the V-belts.
2. Remove the cap from V-belt tensioner assembly.
3. Remove the bolt securing the V-belt tensioner assembly to the generator bracket, and remove the V-belt tensioner assembly.
4. Remove the bolts which secure the idler pulley to the chain cover, and remove the idler pulley.
Dtc b11e0 rollover deployment history
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11E0 ROLLOVER DEPLOYMENT HISTORYDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:This DTC is indicated when the curtain airbag module and the seat belt pretensioner are deployed.Once this DTC is ...
Operation
ENTERTAINMENT > Telematics SystemOPERATION1. REGISTRATION (COMM CHECK)CAUTION:Because it will go back to Factory mode when the signal is weak, that you do not press the i button more than 2 seconds during a communication check. If it had returned to Factory mode, carrying out the CommCheck again. ...
Removal
DRIVE SHAFT SYSTEM > Rear AxleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the c ...