Subaru Crosstrek Service Manual: Removal

1. ROCKER COVER RH

NOTE:

When replacing a single part, perform the work with the engine assembly installed to body.

1. When working on the vehicle

NOTE:

When working on the vehicle, perform the following steps also.

(1) Remove the air cleaner case. Air Cleaner Case > REMOVAL">

(2) Remove the clip (A) from the air intake boot, and loosen the clamp (B) securing the air intake boot to the throttle body.

(3) Remove the air intake boot from the throttle body, and move it to the left side wheel apron.

(4) Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL">

2. Remove the #1 ignition coil and the #3 ignition coil. Ignition Coil > REMOVAL">

3. Remove the intake manifold protector RH.

4. Remove the rocker cover RH.

5. Remove the rocker cover gasket RH, #1 spark plug pipe gasket and #3 spark plug pipe gasket, and remove the liquid gasket.

CAUTION:

• When removing the liquid gasket from engine unit using scraper, use special care not to damage the cam lobe of camshaft RH.

• If the cam lobe of camshaft RH interferes, turn the crankshaft to the position where the scraper does not touch.

When replacing a single part, perform the work with the engine assembly installed to body.

1. When working on the vehicle

NOTE:

When working on the vehicle, perform the following steps also.

(1) Remove the V-belt covers.

(2) Remove the V-belts. V-belt > REMOVAL">

(3) Remove the battery. Battery > REMOVAL">

(4) Remove the air intake duct. Air Intake Duct > REMOVAL">

(5) Align the timing mark (B) on crank pulley to the 0° in timing gauge (A) on chain cover as shown in the figure, and turn the crankshaft by 180° clockwise from that position.

NOTE:

This procedure is required to prevent the rocker cover LH and the cam lobe of camshaft LH contacting with each other when removing the rocker cover LH.

2. Remove the #2 ignition coil and the #4 ignition coil. Ignition Coil > REMOVAL">

3. Remove the intake manifold protector LH.

4. Remove the rocker cover LH.

5. Remove the rocker cover gasket LH, #2 spark plug pipe gasket and #4 spark plug pipe gasket, and remove the liquid gasket.

CAUTION:

• When removing the liquid gasket from engine unit using scraper, use special care not to damage the cam lobe of camshaft LH.

• If the cam lobe of camshaft LH interferes, turn the crankshaft to the position where the scraper does not touch.

Inspection

Installation

Other materials:

Clear memory mode Operation
BODY CONTROL SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, selec ...

Removal
EyeSight > Stereo CameraREMOVALCAUTION:• When the stereo camera or windshield glass has been replaced, removed or installed, always perform the adjustment and inspection of the camera. (When the stereo camera has been replaced with a new part, the camera remains in a failed state until adju ...

Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission CaseDISASSEMBLY1. Remove the oil stopper plate.2. Remove all plugs from the transmission case.3. Remove the oil seal using a screwdriver wrapped with cloth etc.4. Using the ST, remove the ball bearing of the secondary pulley.(1) Remove the ...