Subaru Crosstrek Service Manual: Removal

1. PITCHING STOPPER

1. Disconnect the ground cable from battery.

2. Remove the clip (A) from the air intake boot.

3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).

4. Loosen the clamp (C) which connects the air intake boot and throttle body.

5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.

6. Remove the pitching stopper.

1. Disconnect the ground cable from battery.

2. Lift up the vehicle.

3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">

4. Remove the center exhaust cover.

5. Set the transmission jack.

CAUTION:

Always support the transmission case with a transmission jack.

6. Remove the front crossmember and the rear crossmember.

7. Remove the transmission cushion rubber.

Inspection

Installation

Other materials:

Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3 ...

System operation
Operating conditions The BSD/RCTA will operate when all of the following conditions are met. The ignition switch is in the "ON" position. The BSD/RCTA warning indicator and BSD/RCTA OFF indicator are turned off. The vehicle is driven at speeds above 6 mph (10 km/h) (except when rever ...

Subaru select monitor Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. GENERAL DESCRIPTIONThe on-board diagnosis function of the cruise control system uses Subaru Select Monitor.The on-board diagnosis function operates in two categories, which are used depending on the type of problems;1. Cruise ...