Subaru Crosstrek Service Manual: Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Case
REMOVAL
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">
2. Remove the clutch release lever and the release bearing. Release Bearing and Lever > REMOVAL">
3. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">
4. Remove the bearing mounting bolt.
5. Remove the main shaft rear plate.
(A) | Main shaft rear plate |
6. Remove the bolts and nuts, and separate the transmission case into the right and left cases.
7. Remove the drive pinion shaft assembly.
NOTE:
Use a hammer handle, etc. to remove if too tight.
(A) | Main shaft ASSY |
(B) | Drive pinion shaft assembly |
8. Remove the main shaft assembly.
9. Remove the front differential assembly.
10. Remove the differential side retainers and taper roller bearing outer races on the left and right sides. Front Differential Assembly > REMOVAL">
NOTE:
Do not confuse the right and left taper roller bearing outer races.
11. Remove the reverse idler gear. Reverse Idler Gear > REMOVAL">
12. Remove the shifter fork and rod. Shifter Fork and Rod > REMOVAL">
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission CaseINSPECTIONCheck the transmission case for cracks, damage, or oil leaks. ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission CaseINSTALLATION1. Wipe off grease, oil and dust on the mating surfaces of transmission cases with cleaning solvent.2. Install the reverse i ...
Other materials:
Dtc b2284 brake signal correlation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2284 BRAKE SIGNAL CORRELATIONDTC detecting condition:When the brake signal transmitted via the hard wire and the brake signal transmitted from body integrated unit via CAN comm ...
Dtc p0458 evap system (cpc) purge control valve "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0458 EVAP SYSTEM (CPC) PURGE CONTROL VALVE "A" CIRCUIT LOWDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Mounting SystemREMOVAL1. PITCHING STOPPER1. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.2. Remove the clip (A) from the air intake boot.3. L ...
