Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven Gear

REMOVAL

1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">

2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">

3. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">

4. Remove the extension case assembly.

5. Remove the transfer driven gear.

6. Remove the taper roller bearing outer race.

(A)

Taper roller bearing (transfer case side) outer race

(B)

Taper roller bearing (extension case side) outer race

Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearASSEMBLY1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, ...

Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearDISASSEMBLY1. Using the ST, remove the taper roller bearing (extension case side).ST 498077000REMOVER(A)Taper roller bearing (exte ...

Other materials:

Dtc b14ea intake door actuator circuit short-circuit
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14EA INTAKE DOOR ACTUATOR CIRCUIT SHORT-CIRCUITDTC detecting condition:Intake door actuator potentiometer circuit is shorted.Trouble symptom:FRESH/RECIRC does not operate.Wiring diagram:Air conditio ...

Subaru select monitor Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. GENERAL DESCRIPTIONThe on-board diagnosis function of the cruise control system uses Subaru Select Monitor.The on-board diagnosis function operates in two categories, which are used depending on the type of problems;1. Cruise ...

Dtc u0073 control module communication bus off
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDiagnosis start condition:Ignition voltage remains at 10 V or more for 1 second.DTC detecting condition:Detected when malfunction occurs in CAN line.NOTE:Perform the diagnosis for LAN sys ...

© 2016-2024 Copyright www.sucross.com