Subaru Crosstrek Service Manual: Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and Rod
REMOVAL
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">
2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">
3. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">
4. Remove the transmission case. Transmission Case > REMOVAL">
5. Remove the drive pinion shaft assembly. Drive Pinion Shaft Assembly > REMOVAL">
6. Remove the main shaft assembly. Main Shaft Assembly > REMOVAL">
7. Remove the front differential assembly. Front Differential Assembly > REMOVAL">
8. Drive out the straight pin by tapping it with the ST, and remove the 5th shifter fork.
| ST 398791700 | REMOVER |
(A) | Straight pin |
(B) | 5th shifter fork |
9. Remove the check ball plugs, check ball springs and check balls.
10. Drive out the straight pin by tapping with the ST, and remove the 3rd-4th fork rod and 3rd-4th shifter fork.
NOTE:
When removing the 3rd-4th fork rod, keep other fork rods in neutral. When driving out the straight pin, remove it toward the inside of case so that it does not hit against the case.
| ST 398791700 | REMOVER |
(A) | Straight pin |
(B) | 3rd-4th fork rod |
(C) | 3rd-4th shifter fork |
11. Drive out the straight pin by tapping with the ST, and pull out the 1st-2nd fork rod and 1st-2nd shifter fork.
| ST 398791700 | REMOVER |
12. Remove the snap ring (outer), and pull out the reverse fork rod from the reverse fork rod arm. Then take out the check ball, check ball spring, and interlock plunger from the reverse fork rod arm. And then remove the reverse fork rod.
NOTE:
When pulling out the reverse fork rod arm, be careful not to let the ball pop out of arm.
13. Remove the reverse shifter lever.
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSPECTION1. Check the shifter fork and fork rod for damage. Replace if it is damaged.2. Gearshift mechanismRepair or replace the gea ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSTALLATION1. Install the check ball spring and check ball to the reverse fork rod arm, and press in the ST.ST 399411700ACCENT BA ...
Other materials:
Inspection
DIFFERENTIALS > Rear Differential (VA-type)INSPECTIONWash all the disassembled parts clean, and examine them for wear, damage or other defects. Repair or replace the defective parts as necessary.1. Hypoid driven gear and drive pinion• If there is evidently an abnormal tooth contact, find ou ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSTALLATIONCAUTION:• Replace the O-rings on the hose - pressure suction and discharge with new parts, and then apply compressor oil.• After replacing the compressor assembly, adjust the amount of the compressor oil. Compressor Oil ...
Dtc p0951 auto shift manual control circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:Manual mode can not be set.CAUTION:Use the check board whe ...
