MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler Gear
REMOVAL
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">
2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">
3. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">
4. Remove the transmission case. Transmission Case > REMOVAL">
5. Remove the drive pinion shaft assembly. Drive Pinion Shaft Assembly > REMOVAL">
6. Remove the main shaft assembly. Main Shaft Assembly > REMOVAL">
7. Remove the front differential assembly. Front Differential Assembly > REMOVAL">
8. Remove the shifter forks and rods. Shifter Fork and Rod > REMOVAL">
9. Pull out the straight pin, and remove the reverse idler gear shaft, adjusting washer, reverse idler gear and washer.
(A) | Straight pin |
(B) | Reverse idler gear shaft |
(C) | Reverse idler gear |
(D) | Adjusting washer |
(E) | Reverse idler gear washer |
(F) | Reverse shifter lever |
10. Remove the reverse shifter lever.
Dtc b278d id code box judgment circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B278D ID CODE BOX JUDGMENT CIRCUITDTC detecting condition:• When ID code box setting is set to OFF, ID code box ON input is detected.• When ID code box setting is se ...
Note
ENTERTAINMENT > Navigation SystemNOTEFor procedure of each component in the navigation system, refer to the respective section.• Navigation unit: Navigation Body">• GPS antenna: GPS Antenna"> ...
Register transmitter (id) Operation
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Register Transmitter (ID)OPERATIONPerform the registration procedure of the transmitter in the following cases:• Transmitter is replaced.• TPMS & keyless entry CM or TPMS CM is replaced.NOTE:• If registration of the transmitter ...