MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center Differential
REMOVAL
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">
2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">
3. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">
4. Remove the extension case assembly.
5. Remove the transfer driven gear. Transfer Driven Gear > REMOVAL">
6. Remove the center differential.
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Pulley and Secondary PulleyINSTALLATION1. Select shims for pulley alignment. Primary Pulley and Secondary Pulley > ADJUSTMENT">2. Install the seal ring to the input shaft.NOTE:• Use new seal rings.• When installing the se ...
Automatic engine shutdown
The remote engine start system will
automatically shut down or will not start
the engine under the following conditions.
The total run-time has exceeded 20
minutes.
Any door or the rear gate is opened.
The select lever is moved to any
position other than "P".
The engine hood is opene ...
Dtc p0328 knock/combustion vibration sensor 1 circuit high bank 1 or single sensor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0328 KNOCK/COMBUSTION VIBRATION SENSOR 1 CIRCUIT HIGH BANK 1 OR SINGLE SENSORDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Poor driving performance• Knocking occursCAUT ...