Subaru Crosstrek Service Manual: Removal
LUBRICATION(H4DO) > Oil Pan
REMOVAL
1. OIL PAN
1. Disconnect the ground cable from battery. NOTE">
2. Lift up the vehicle.
3. Remove the under cover. Front Under Cover > REMOVAL">
4. Drain the engine oil. Engine Oil > REPLACEMENT">
5. Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL">
6. Remove the bolts which secure oil pan to oil pan upper.
7. Insert an oil pan cutter blade into the gap between oil pan upper and oil pan, and remove the oil pan.
CAUTION:
Do not use a screwdriver or similar tool in place of oil pan cutter.
8. Remove the liquid gasket from the oil pan and the oil pan upper.
2. OIL PAN UPPER
1. Remove the engine from the vehicle. Engine Assembly > REMOVAL">
2. Remove the water pump. Water Pump > REMOVAL">
3. Remove the thermostat cover. Thermostat > REMOVAL">
4. Remove the water pipe assembly. Water Pipe Assembly > REMOVAL">
5. Remove the chain cover. Chain Cover > REMOVAL">
6. Remove the oil pan. Oil Pan > REMOVAL">
7. Remove the oil level switch. Oil Level Switch > REMOVAL">
8. Remove the bolts which secure oil pan upper to cylinder block, and remove the oil pan upper.
NOTE:
Remove the bolt (a) shown in the figure using TORX® bit T45.
9. Remove the baffle plate from the oil pan upper.
10. Remove the oil strainer from the oil pan upper.
11. Remove stud bolts from the oil pan upper.
12. Remove the O-ring from the cylinder block.
13. Remove the clutch housing cover from the oil pan upper. (MT model)
(A) | Oil pan upper | (B) | O-ring | (C) | Baffle plate |
(D) | Stud bolt | (E) | Oil strainer | (F) | O-ring |
(G) | Clutch housing cover (MT model) |
14. Remove the liquid gasket from oil pan upper and cylinder block.
Inspection
LUBRICATION(H4DO) > Oil PanINSPECTIONCheck that the oil pan, oil pan upper, oil strainer and baffle plate do not have deformation, cracks or damage. ...
Installation
LUBRICATION(H4DO) > Oil PanINSTALLATION1. OIL PAN1. Apply liquid gasket to the mating surface of the oil pan upper as shown in the figure, and install the oil pan.NOTE:• Before applying liqui ...
Other materials:
Removal
EXTERIOR/INTERIOR TRIM > Sun VisorREMOVAL1. Remove the sun visor assembly.(1) Remove the cap - sun visor, and then remove the screws.(2) Disconnect the connector and remove the sun visor assembly.2. Remove the hook - sun visor.(1) Press both sides using a flat tip screwdriver.(2) Remove the hook ...
Dtc u0402 invalid data received from tcm
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0402 INVALID DATA RECEIVED FROM TCMFailure counter diagnosis of automatic transmission control module (TCM)NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Manual transmission
The manual transmission is a fully synchromeshed,
5-forward-speed and 1-reverse-
speed transmission.
The shift pattern is shown on the shift
lever knob. When shifting from 5th gear to
reverse gear, first return the shift lever to
the neutral position then shift into reverse
gear.
To ...
