Subaru Crosstrek Service Manual: Removal

Subaru Crosstrek Service Manual / Lubrication(h4do) / Engine oil filter / Removal

LUBRICATION(H4DO) > Engine Oil Filter

REMOVAL

CAUTION:

If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.

1. OIL FILTER

1. Turn the ignition switch to OFF.

2. Remove the oil filter.

NOTE:

Clean off water or dust from the oil element mating surface using air.

• Oil filter (black)

Remove the oil filter using ST.

ST 18332AA000

OIL FILTER WRENCH (outer diameter: 68 mm (2.68 in) for oil filter)

• Oil filter (blue)

Remove using a general tool (65/67 mm 14 Flutes).

2. OIL PUMP UNION

1. Remove the oil filter. Engine Oil Filter > REMOVAL">

2. Remove the oil pump union from the chain cover.

Inspection

LUBRICATION(H4DO) > Engine Oil FilterINSPECTION1. After installing the oil filter, run the engine and check for oil leakage.NOTE:The filter element and filter case are permanently jointed; therefor ...

Installation

LUBRICATION(H4DO) > Engine Oil FilterINSTALLATION1. OIL FILTERCAUTION:Do not tighten excessively, or oil may leak.1. Clean the oil filter installation surface.2. Obtain a new oil filter and apply a ...

Other materials:

List
TELEMATICS SYSTEM (DIAGNOSTICS) > System Operation Check ModeLISTSystem operation check modeNoteGREEN LED LightingGREEN LED illuminates/flashes/goes off.GREEN LED FlashingGREEN LED OFFRED LED LightingRED LED illuminates/flashes/goes off.RED LED FlashingRED LED OFFSpeaker ONOutputs to speaker. ...

Installation
FRONT SUSPENSION > Front CrossmemberINSTALLATION1. Check the crossmember for damage or cracks, and correct or replace if defective.2. Install the universal joint assembly - steering. Universal Joint > INSTALLATION">3. Install each part in the reverse order of removal.CAUTION:• U ...

Electrical specification
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONNOTE:The terminal numbers of the power steering control module connectors are as indicated in the figure.ContentsTerminal No.Input/output signalMeasured value and measuring conditionsPower supp ...