Subaru Crosstrek Service Manual: Removal
LIGHTING SYSTEM > SRF OFF Switch
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the cover assembly - instrument panel LWR driver OUT. Instrument Panel Lower Cover > REMOVAL">
3. Release the claws, and then remove the cover.
4. Release the claws and remove the SRF OFF switch.
Inspection
LIGHTING SYSTEM > SRF OFF SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3OFF1 M? or moreONLess ...
Installation
LIGHTING SYSTEM > SRF OFF SwitchINSTALLATIONInstall each part in the reverse order of removal. ...
Other materials:
Inspection
SECURITY AND LOCKS > Keyless Entry SystemINSPECTION1. SYMPTOM CHARTSymptomsRepair orderReferenceNone of the functions of the keyless entry system operate.1. Check the keyless transmitter battery. Keyless Entry System > INSPECTION">2. Remove and visually inspect the following fuses.&bul ...
Dtc p0068 map/maf - throttle position correlation
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0068 MAP/MAF - THROTTLE POSITION CORRELATIONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...
To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to
accelerate the vehicle to the desired
speed.
2. Press the "RES/SET" switch to the
"SET" side once. Now the desired speed
is set and the vehicle will keep running at
that speed without depressing the accelerator
pedal.
NOTE
U.S.-spec. models
If t ...
