Subaru Crosstrek Service Manual: Removal
LIGHTING SYSTEM > Spot Map Light
REMOVAL
1. MODELS WITHOUT EyeSight
1. Disconnect the ground cable from battery. NOTE">
2. Remove the light assembly - map.
CAUTION:
When using a flat tip screwdriver, use an appropriate sized tool for the insertion opening, apply protective tape or cloth around the tool, and be careful not to cause damage.
(1) Release the claws and remove the lens.
(2) Remove the screws and pull out the light assembly - map.
• Model without sunroof
• Model with sunroof
(3) Disconnect the connector and remove the light assembly - map and the bulb.
CAUTION:
Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
2. MODELS WITH EyeSight
NOTE:
The spot map light is a single unit with the stereo camera cover.
1. Disconnect the ground cable from battery. NOTE">
2. Remove the stereo camera cover. Stereo Camera > REMOVAL">
CAUTION:
When using a flat tip screwdriver, use an appropriate sized tool for the insertion opening, apply protective tape or cloth around the tool, and be careful not to cause damage.
3. Release the claws and remove the lens.
4. Remove the bulb.
CAUTION:
Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
Inspection
LIGHTING SYSTEM > Spot Map LightINSPECTION1. SPOT MAP LIGHT BULB1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace ...
Installation
LIGHTING SYSTEM > Spot Map LightINSTALLATIONInstall each part in the reverse order of removal. ...
Other materials:
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF FilterREMOVALNOTE:• Although CVTF filter is a maintenance-free part, replace it if a large quantity of wear debris and metal particles are found in CVTF and CVTF filter.• For removal of CVTF filter, refer to “Transmission Case&rdq ...
Dtc b1900 short in front p/t rh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1900 SHORT IN FRONT P/T RHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (RH) circuit is shorted.• Pretensioner (RH) is faulty.• Pretensioner harness ...
Removal
EXTERIOR/INTERIOR TRIM > Roof MoldingREMOVALCAUTION:Be careful not to damage the body.1. Remove the roof rail assembly. (model with roof rail) Roof Rail > REMOVAL">2. Turn over the front end of the molding - roof.3. Slide the inner fastener in the direction of the arrow using a flat t ...
