Subaru Crosstrek Service Manual: Removal
LIGHTING SYSTEM > Rear Height Sensor
REMOVAL
CAUTION:
Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.
1. Disconnect the ground cable from battery. NOTE">
2. Lift up the vehicle, and remove the left rear wheel.
3. Remove the sensor assembly - headlight beam leveler.
CAUTION:
Do not disassemble the sensor and lever.
(1) Disconnect the connector.
(2) Remove the nuts, and remove the sensor assembly - headlight beam leveler.
Inspection
LIGHTING SYSTEM > Rear Height SensorINSPECTION1. Connect three dry cell batteries (1.5 V) in series.NOTE:• Use new dry-cell batteries.• Using a circuit tester, check that the initial vo ...
Installation
LIGHTING SYSTEM > Rear Height SensorINSTALLATION1. Install each part in the reverse order of removal.Tightening torque:Sensor assembly - headlight beam leveler: 7.5 N·m (0.76 kgf-m, 5.5 ft-l ...
Other materials:
Engine oil setting
1. Perform the preparation steps according
to "Preparation for maintenance settings"
2. Operate the "
" or "
" switch to
select the "Engine Oil" item. Then push
the
button.
3. Select the setting location (month, day,
year or distance) by operating the "
" or ...
Read diagnostic trouble code (dtc) Operation
LAN SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «All diagnosis code».NOTE:• For detail ...
Dtc c0071 steer angle sensor op
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0071 STEER ANGLE SENSOR OPDTC detecting condition:Steering angle sensor output is faulty.Trouble symptom:• VDC does not operate.• EyeSight does not operate.Wiring diagram:Vehicle ...
