Subaru Crosstrek Service Manual: Removal
LIGHTING SYSTEM > Light Control Sensor
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the sensor - automatic light.
CAUTION:
Be careful not to damage the sensors and interior trims when removing.
(1) Release the connectors and claws, and remove the grille front defroster.
(2) Release the claws, and then remove the sensor - automatic light from the grille front defroster.
Inspection
LIGHTING SYSTEM > Light Control SensorINSPECTION1. Turn the ignition switch to ON.2. Set the lighting switch to AUTO position.3. Check the voltage between the sensor terminals.Preparation tool:Circ ...
Installation
LIGHTING SYSTEM > Light Control SensorINSTALLATIONInstall each part in the reverse order of removal. ...
Other materials:
Dtc c0073 abnormal lateral g sensor output
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0073 ABNORMAL LATERAL G SENSOR OUTPUTDTC detecting condition:Defective lateral G sensorTrouble symptom:• VDC does not operate.• EyeSight does not operate.STEPCHECKYESNO1.CHECK IN ...
Installation
LIGHTING SYSTEM > Turn Signal Light & Hazard Light UnitINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the reve ...
Disassembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the front hub unit bearing (a).CAUTION:• Be careful not to hammer the hub bolts. This may deform the hub unit bearing.• Do not reuse the hub bolt.NOTE:Since the hub ...
