LIGHTING SYSTEM > License Plate Light
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the license plate light.
(1) Release the claws and pull out the license plate light.
(2) Disconnect the connector and remove the bulb socket and bulb from the license plate light.
CAUTION:
Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
Casual speech recognization
Due to natural language speech recognition
technology, this system enables recognition
of a command when spoken
naturally. However, the system cannot
recognize every variation of each command.
In some situations, it is possible to
omit the command for the procedure and
directly state the de ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Sub Level SensorINSPECTION1. Check that the fuel sub level sensor has no damage.2. Measure the fuel sub level sensor float position.(1)FULL(2)EMPTY(3)Datum pointsFloat positionStandardFULL to Datum point (A)5.31±3.5 mm (0.209±0.138 in)EMPTY to Datum po ...
Inspection
CLUTCH SYSTEM > Clutch SwitchINSPECTION1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT">• Make sure that engine does not start with clutch pedal no ...