LIGHTING SYSTEM > High-mounted Stop Light
REMOVAL
1. CROSSTREK MODEL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL">
3. Remove the light assembly - high-mounted.
(1) Remove the nut.
(2) From the inside of the rear gate, push the claws on both side of the light assembly - high-mounted to take it out toward vehicle rear.
(3) Disconnect the connector and remove the light assembly - high-mounted.
Profiles
This system supports the following services.
NOTE
If your cell phone does not support HFP, registering the Bluetooth
phone or using OPP, PBAP, or SPP profiles individually
will not be possible.
If the connected Bluetooth device version is older than recommended
or incompatible, the ...
Dtc p0122 throttle/pedal position sensor/switch "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0122 THROTTLE/PEDAL POSITION SENSOR/SWITCH "A" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving perf ...
Dtc p0222 throttle/pedal position sensor/switch "b" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0222 THROTTLE/PEDAL POSITION SENSOR/SWITCH "B" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performance• Engin ...