LIGHTING SYSTEM > Headlight Assembly
REMOVAL
CAUTION:
• Do not perform work with wet hands, because there is a possibility of electrical shock.
• The HID type uses very high voltages for the lighting circuit. Make sure that the power supply is turned OFF before working.
1. Disconnect the ground cable from battery. NOTE">
2. Remove the air intake duct. (When removing RH side) Air Intake Duct > REMOVAL">
3. Remove the clip, and remove the bracket - grille.
CAUTION:
To prevent damage to the bracket - grille, make sure to remove all clips.
4. Remove the bumper face - front. Front Bumper > REMOVAL">
5. Remove the bolts and clips, and remove the bracket - front bumper corner.
6. Remove the light assembly - head.
(1) Disconnect the connector.
(2) Remove the bolts and clips, and remove the light assembly - head.
Headlights
To turn on the headlights, turn the knob on
the end of the turn signal lever.
" " position
Instrument panel illumination, headlights,
parking lights, front side marker lights, rear
side marker lights, tail lights and license
plate lights are on.
" " position
Instrument panel illumination ...
Preparation tool
BODY CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, ...
Removal
WHEEL AND TIRE SYSTEM > Tire Pressure Monitoring SystemREMOVAL1. TRANSMITTER (TIRE INFLATION PRESSURE SENSOR)1. Remove the wheels from the vehicle. Tire and Wheel > REMOVAL">2. Remove the tires from wheels.CAUTION:Use a tire changer when removing the tire from the wheel.3. Loosen the ...