LIGHTING SYSTEM > Glove Box Light
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the pocket assembly.
(1) Attach the protective tape (a) to the panel center LWR.
(2) Remove the damper COMPL - pocket.
(3) Release the stoppers and remove the pocket assembly by pulling it toward you.
3. Remove the light - pocket.
(1) Release the claws and remove the light - pocket cover from the back panel - pocket.
(2) Disconnect the connector and remove the light - pocket from the cover.
Dtc c1731 g sensor abnormal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1731 G SENSOR ABNORMALNOTE:For the diagnostic procedure, refer to “DTC C1732 LATERAL G SENSOR”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1732 LATERAL G ...
Radar sensor
Adjustment
Blind Spot Detection/Rear Cross Traffic Alert > Radar SensorADJUSTMENT1. RADAR AXIS ADJUSTMENTCAUTION:• After removal/installation or replacement of the radar sensor, perform the radar axis adjustment.• The procedure for the master is only shown here. However the procedure ...
Inspection
SECURITY AND LOCKS > Keyless Access Indoor AntennaINSPECTION1. Check the setting by performing Keyless access system check using the Subaru Select Monitor. Keyless Access System Check > OPERATION">2. Disconnect the Subaru Select Monitor. Operate the touch sensor of the door outer hand ...