LIGHTING SYSTEM > Front Fog Light Assembly
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Lift up the vehicle.
3. Remove the screw and clips, and turn over the front side of the mud guard - front.
4. From the bottom of the bumper face - front, remove the fog light assembly - front.
(1) Disconnect the connector.
(2) Remove the bolts and clips, and remove the fog light assembly - front.
• Model without SRF
• Model with SRF
Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxINSTALLATION1. Insert the steering gearbox assembly into crossmember, being careful not to damage the boot of the steering gearbox assembly.2. Install the steering gearbox assembly to the crossmember by tightening the bolts t ...
Removal
DRIVE SHAFT SYSTEM > Front Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axl ...
Preparation tool
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS18769AA010EXPANDER PULLEYUsed for removing and installing the secondary pulley assembly.18767AA010BEARING REMOVERUsed for removing the ball bearing of transfer cl ...