Subaru Crosstrek Service Manual: Removal
LIGHTING SYSTEM > Combination Switch (Light)
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Set the tire to the straight-ahead position.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL">
4. Remove the steering wheel. Steering Wheel > REMOVAL">
5. Remove the cover assembly - column.
(1) Release the screws and claws.
(2) Remove the cap - key cylinder (a).
(3) Release the claw, and remove the cover assembly - column UPR and the cover assembly - column LWR.
A | Model without keyless access with push button start | B | Model with keyless access with push button start |
6. Remove the steering roll connector. Roll Connector > REMOVAL">
7. Remove the switch assembly - combination wiper select. Combination Switch (Wiper) > REMOVAL">
8. Remove the switch assembly - combination turn dimmer.
(1) Disconnect the connector, and loosen the clamp to release the claws.
(2) Pull out the switch assembly - combination turn dimmer from the column assembly - steering.
Inspection
LIGHTING SYSTEM > Combination Switch (Light)INSPECTIONMeasure the resistance between connector terminals. If it is not within the standard value, replace the switch assembly - combination turn dimm ...
Installation
LIGHTING SYSTEM > Combination Switch (Light)INSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “A ...
Other materials:
Disassembly
BRAKE > Front Disc Brake AssemblyDISASSEMBLYCAUTION:Be careful not to allow foreign matter to enter the brake hose connector.1. Remove mud and foreign matter from the caliper body.2. Remove the piston - disc brake.(1) Place a wooden block in the caliper body as shown in the figure to prevent the ...
Adjustment
WIPER AND WASHER SYSTEMS > Front Wiper ArmADJUSTMENT1. Operate the windshield wiper once.2. Check that the wiper blade is aligned with the point mark.3. Make sure that there is a gap of 1 mm (0.04 in) or more between the hose and the cover joint and between the hose and the joint wash ...
Cleaning ventilation grille
Front ventilation inlet grille
Always keep the front ventilation inlet grille
free of snow, leaves, or other obstructions
to ensure efficient heating and defrosting.
Since the condenser is located in front of
the radiator, this area should be kept clean
because cooling performance i ...
