INTAKE (INDUCTION)(H4DO) > Air Cleaner Case
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the air intake duct. Air Intake Duct > REMOVAL">
3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B).
4. Loosen the clamp (A) which secures the air intake boot to the air cleaner case (rear), and then remove the clip (B) from the air cleaner case (front).
5. Remove the air cleaner case (rear) and air cleaner element.
6. Remove the bolt (A) and nut (B) which secure the air cleaner case (front) to the body.
7. Remove the air cleaner case (front).
Caution
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > General DescriptionCAUTION1. BSD/RCTA(1) In some cases, BSD/RCTA may not work correctly under the following conditions.• In bad weather such as heavy rain, fog, snow, sand storm, etc.• When ice, snow, dirt, etc. cover the r ...
Multi information display (models with type B combination meter)
WARNING
Always pay adequate attention to
safe driving when operating the
multi information display while the
vehicle is in motion. When operation
of the multi information display
interferes with your ability to concentrate
on driving, stop the vehicle
before performing operations on the
scr ...
Removal
EXHAUST(H4DO) > MufflerREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Turn the ignition switch to OFF.2. Lift up the vehicle.3. Remove the bolts and self-locking nuts which secure the rear exhaust pipe to the muffler.4. Apply a c ...