Subaru Crosstrek Service Manual: Removal

Subaru Crosstrek Service Manual / Ignition(h4do) / Spark plug / Removal

IGNITION(H4DO) > Spark Plug

REMOVAL

Spark plug:

Refer to “SPECIFICATION” for spark plug. General Description > SPECIFICATION">

1. RH SIDE

1. Disconnect the ground cable from battery. NOTE">

2. Remove the air cleaner case. Air Cleaner Case > REMOVAL">

3. Disconnect the connector from ignition coil.

NOTE:

While pressing the spring (a) shown in the figure, slide it in the direction of the arrow with a clip remover.

4. Remove the ignition coil.

5. Remove the spark plug with a spark plug socket.

2. LH SIDE

1. Disconnect the ground cable from battery. NOTE">

2. Disconnect the connector from ignition coil.

NOTE:

While pressing the spring (a) shown in the figure, slide it in the direction of the arrow with a clip remover.

3. Remove the ignition coil.

4. Remove the spark plug with a spark plug socket.

Inspection

IGNITION(H4DO) > Spark PlugINSPECTION1. Check the spark plug for abnormalities. If defective, replace the spark plug.(A)Terminal damage(B)Crack or damage in insulator(C)Damaged gasket2. Check the s ...

Installation

IGNITION(H4DO) > Spark PlugINSTALLATION1. RH SIDEInstall in the reverse order of removal.CAUTION:Degrease the ignition coil installation portion and the mounting bolts.Tightening torque:Spark plug1 ...

Other materials:

Check adaptive cruise control indicator light/constant speed cruise control indicator light and cruise set indicator light
EyeSight (DIAGNOSTICS) > Diagnostics with PhenomenonCHECK ADAPTIVE CRUISE CONTROL INDICATOR LIGHT/CONSTANT SPEED CRUISE CONTROL INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHTTROUBLE SYMPTOM:Adaptive cruise control or conventional cruise control can be set, but adaptive cruise control indicator li ...

Dtc b2a0a red led circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0A RED LED CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:• Current in LED is less than 1 mA. (Improper LED connection, etc.)• Current is more than 200 mA for at le ...

Contrast setting
1. Perform the preparation steps according to "Preparation for image quality and volume settings" 2. Operate the " " or "" switch to select the "Contrast" item. Then push the button. 3. Select a contrast level by operating the " " or " " switch, and confirm the setting b ...